Ports; Reset Button - UTT HiPER 811 Quick Manual

Blinking
TRF
Off
Blinking
FLT
Off
Green
Link/Act Blinking
Off
Green
100M
Off

2.1.2 Ports

Interface
LAN (1, 2, 3, 4)
WAN

2.1.3 Reset Button

If you want to reset the Device to the factory default settings, press and hold in the Reset
button for more than 5 seconds when the Device is on, then release the button. After that,
the Device will restart with the factory default settings.
Note
Network activity on the Device.
No activity on the Device.
The Device is not operating correctly.
The Device is operating correctly.
Valid link on the associated port.
Network activity on the associated port.
No link established on the associated port.
The associated port is connected at 100Mbps.
The associated port is connected at 10Mbps.
Table2-1 LEDs Description
Description
These Ethernet ports connect the Device to wired computers,
hubs, switches, and other Ethernet network devices.
This port connects to a cable or DSL modem, or other Ethernet
network device.
Table2-2 Ports Description
Page 9