Connecting The Device - UTT HiPER 811 Quick Manual

2.2

Connecting the Device

Before you install the Device, please make sure your PC can connect to the Internet
through your broadband service successfully. If there is any problem, please contact with
your ISP for help.
After that, please install the Device according to the following steps. Don't forget to pull
out the power plug and keep your hands dry.
Power off your PC(s), Cable/DSL modem, and the Device.
Step 1
Connect the PC(s) and the Switches or Hubs on your LAN to the Device's LAN
Step 2
port (see Figure 2-2).
Connect the Cable/DSL modem to the Device's WAN port (see Figure 2-2).
Step 3
Connect the power cord to the power connector on the back panel of the
Step 4
Switch. Then plug the other end of the power cord to a grounded three-prong
AC power outlet. The Device will start to work automatically.
Power on your network devices, PCs, Switches, Hubs, and so on.
Step 5
Figure 2-2 Connecting the Device
Page 11