Advertisement
Type B
Structure of the Tool and Part Names
Locator pin
Crimper
Crimper fixing screw
Contact feed bar
Anvil
Crimper
Head
Movable cutter
Fixing screw
Anvil
Example of Failure
Failure Item
Failure Description
1)Malformation of
Pull strength is out of specification.
the crimped area
(Wire barrel)
2)Deformation of
the terminal
twist
1.Bend
2.Twist
Rolling
3.Deformation
of the barrel
Incomplete crimping
of the barrel
3)Variation in
The crimping height
crimp height
of the tool is not fixed.
Wire crimping part
Grip
Shaft pin
The wire size is out of
the specification, or
abrasion of the tool
The terminal is not
set in position against
Bent up
the crimper and anvil.
twist
Bent down
Occurred when grips
are incompletely
tightened (tightened
half way) but in the
position where they can
be open due to the
abrasion or deformation
of the ratchet.
Tool identification number
With this tool, a strip of contacts can be crimped easily with the applicable wire
Wires
by using a set of crimper and anvil. (No need to replace the crimper and anvil.)
Cladding insulator crimping part
Selecting the appropriate crimper
Cause
1.Requisite blades are attached on top and bottom of the crimper.
2.The number of applicable size of the wire is engraved on the crimper.
3.Select the crimper to the size of the wire.
4.When replacing the crimper, pull out the locator pin.
(The locator pin can be pulled out with fingers easily.)
5.Install the appropriate crimper and fix it with the locator pin.
Procedures
1.Make sure that the tool number and the wire size are met.
2.Cut the strip of contacts in 20cm.
3.Insert the cut strip of contacts into the contact feed bar.
4.Feed the contacts to the proper position.
5.Strip the wire and insert the contact appropriately.
6.Close the grips until the latchet is released.
7.Open the grips to pick up the contact.
8.Feed the contact with stripped wire to the proper position.
9.Make sure that the shape of the crimped work is appropriate.
Ratchet
Advertisement
