Advertisement
HAND CRIMPING TOOLS
Type
A
Structure of the Tool and Part Names
Locator pin
Crimper
Anvil
Figure A"
Wire crimper
Contact
Wires
Example of Failure
Failure Item
Malformation of
1)
Pull strength is
the crimped area
out of specification.
(Wire barrel)
2)Deformation
Bent up
of the terminal
Twisted
1.Bend
Rolling
2.Twist
Bent down
3.Deformation
of the barrel
Incomplete
crimping of the barrel
3)Variation in
The crimping height
crimp height
of the tool is not fixed.
Cladding insulation crimper
Crimper
Cladding insulation
Anvil
Failure Description
The wire size is out of
the specification,
or abrasion of the tool
The terminal is not
set in position against
the crimper and anvil.
Twisted
Occurred when grips
are incompletely
tightened (tightened
half way) but in the
position where they can
be open due to the
abrasion or deformation
of the ratchet.
Tool identification number
Ratchet
This tool can crimp an applicable wire easily with a set of crimper and anvil.
No need to replace the crimper and anvil.
Selecting the appropriate crimper
Cause
1.Requisite blades are attached on top and bottom of the crimper.
2.Combine blades for the crimper so that chamfered planes are faced.
3.Select the crimper to the size of the wire.
4.The number of applicable size of the wire is engraved on the crimper.
5.When replacing the crimper, pull out the locator pin.
(The locator pin can be pulled out with fingers easily.)
は素手
6.Install the appropriate crimper and fix it with the locator pin.
珥上歯型をセットしロケーターピンで固定してください。
Procedures
1.Make sure that the tool number and the wire size are met.
2.Open the grips fully.
3.Set the contact appropriately as shown in Figure A".
Note: The cladding insulation is placed at the side on which
〈注〉 （ 刻印端子の被覆圧着側です。 ）
the engraved indications are shown.
4.Insert the stripped wire as shown in Figure A".
5.Close the grips fully until the ratchet is released.
6.Open the grips to pick up the contact.
7.Make sure that the crimped work is free from defect.
簡単に抜けます）
Advertisement
