Advertisement
5. MAINTENANCE
ABOUT PRODUCTION YEAR
1
This product bears production number at
the lower part of the grip of the main body.
The two digits of the number from left indi-
cates the production year.
(Example)
0 8 8 2 6 0 3 5 D
Year 2008
DO NOT FIRE THE STAPLER WHEN IT IS
2
EMPTY
USE A 3-PIECE AIRSET
3
Failure to use a 3-piece airset allows the
moisture and dirt inside compressor to pass
into the tool directly. This causes rust and
wear, and results in a poor operating per-
formance. The hose length between airset
and tool should be no longer than 5 m since
a longer length results in a reduction in air
pressure.
USE RECOMMENDED OIL
4
The velocite or turbine oil should be used to
lubricate the tool. Upon completion of op-
erations, place 2 or 3 drops of oil into the air
plug inlet with the jet oiler. (Recommended
Oil : ISO VG32)
INSPECT AND MAINTAIN DAILY OR
5
BEFORE OPERATION
WARNING
Disconnect air supply and empty the maga-
zine when inspecting or maintaining the tool.
(1) Drain air line filter and compressor
(2) Keep lubricator filled in air 3-pieces set
(3) Clean filter element of air 3-pieces set
(4) Tighten all screws
(5) Keep contact arm moving smoothly
6. STORAGE
When not in use for an extended period,
1
apply a thin coat of the lubricant to the steel
parts to avoid rust.
Do not store the tool in a cold weather en-
2
vironment. Keep the tool in a warm area.
When not in use, the tool should be stored
3
in a warm and dry place. Keep out of reach
of children.
All quality tools will eventually require ser-
4
vicing or replacement of parts because of
wear from the normal use.
7. TROUBLE SHOOT-
ING/REPAIRS
The troubleshooting and/or repairs shall be
carried out only by the MAX CO., LTD. author-
ised distributors or by other specialists.
18
Advertisement
