Increasing Fan Speed
Testing the drainage
Prepare a little water about 2 liters.
1
Open the cover of water supply intake by turning and pulling the cover.
2
Pour water into the the indoor unit as shown in figure.
Note
I f you do not pour water inside the water supply intake,
water may spill from the indoor unit.
3
Confirm that the water flows out through the drain hose.
4
When the drain pump is installed, operate the unit as cooling mode and check a
drain pump pumping.
5
Check drain water drops at the end of the drain pipe.
6
Make sure there is no water leak at the drainage.
7
Reassemble the cover of water supply intake.
Water supply intake
Water supply intake
23
E-