Renault Captur Driver's Handbook Manual page 179

OPERATING FAULTS
Electrical equipment
Steering becomes heavy.
The "2WD" mode and electronic fault
warning lights come on.
The system will not switch to
"2WD" mode or "4WD Lock" mode.
The "AUTO" mode remains active
Traces of condensation in the lights.
The front seat belt reminder light
comes on when the seat belts are
fastened.
(6/6)
POSSIBLE CAUSES
Assistance overheating.
Fault in the assistance system.
Fault in the 4-wheel drive system.
Fault in the 4-wheel drive system.
Traces of condensation may be a nat-
ural phenomenon caused by varia-
tions in temperature.
In this case, the traces will disappear
slowly once the lights are switched
on.
An object is stuck between the floor
and the seat and is disrupting the op-
eration of the sensor.
WHAT TO DO
Drive carefully at reduced speed, be aware
of the level of force in the steering wheel
needed to turn the wheels. Consult an ap-
proved dealer.
Drive as soon as possible at a moderate
speed to an approved dealer. The problem
may be resolved by replacing the wheels.
Contact an approved dealer as soon as
possible.
Remove all objects from underneath the
front seats.
5.35