Belkin F9K1015au User Manual page 16

aDvanCeD seTTInGs
Wi-fi Protected setup
Your Wi-Fi Range Extender supports the Wi-Fi Protected Setup™
(WPS) specification, which simplifies the setup of a wireless
network. WPS uses familiar methodologies, such as typing in
a Personal Identification Number (PIN) or pushing a button,
to enable users to automatically configure network names and
strong WPA/WPA2 data encryption and authentication.
Using Wi-fi Protected setup™
Belkin recommends that you set up WPA2 as your wireless security.
WPS does not provide additional security, but rather simplifies
the addition of wireless devices to your wireless network. You
may use either the Push Button Configuration (PBC) method or
PIN method to allow a device access to your wireless network.
PbC: Push and hold the WPS button located on the front of your
Range Extender for two seconds and the security LED will flash,
indicating that WPS has been initiated. Then, initiate WPS on the client
device within two minutes (refer to your client's documentation on this
procedure). The wireless device and Range Extender will automatically
exchange a security key and establish a secure connection.
PIn: The client device has a WPS PIN number (eight digits) that
will be provided to you when you initiate the connection to the
Range Extender. Enable WPS through the screen illustrated to the
below. Enter the client's PIN into the Range Extender's internal
registrar (accessed through this screen). The client will be securely
enrolled into your wireless network within two minutes.
14