Charging A T1 Battery In A Device; Turning A Talkman Wearable Computer On; Turning A Talkman Wearable Computer Off; Powering Off A Wearable Computer - Vocollect Talkman A500 Hardware Documentation

24 | OpenTopic | Talkman

Charging a T1 Battery in a Device

1. Remove the wearable computer from the holster.
2. Disconnect the headset from the wearable computer.
3. Insert the wearable computer into an open slot on the charger.
4. After the wearable computer has been placed into the charger, make sure that the LED indicator on the
wearable computer turns on and is green.
a) If the LED does not turn on after 30 seconds, remove the wearable computer from the charger slot and
then place it into the slot again.
b) If the LED indicator still does not turn on, try another charger slot.
Caution: Do not attempt to place the device into the charger unless you have first disconnected the
headset.

Turning a Talkman Wearable Computer On

Before you turn on a wearable computer, make sure a headset and charged battery are properly connected
to it.
1. Press the Play/Pause button on the wearable computer.
The LED indicator first turns solid red while the processor reboots. It then flashes red and green, turns
solid, blinks red, then turns solid green (A500, T5-series and T2-series) or the LED indicator turns solid
green (T1).
2. The wearable computer says, "Current operator is operator name . Please keep quiet for a few seconds."
The device then starts a noise sample.
3. After a brief pause, it says, "Please wait." After another pause, the device begins asking questions or
providing instructions.

Turning a Talkman Wearable Computer Off

Press and hold the Play/Pause button on the device until the LED indicator turns red.
After a few seconds, it says, "Powering off." The device turns off, and the LED indicator light goes out.
Caution:
•
•

Powering Off a Wearable Computer

You can use a button control or forced reset to force a Talkman wearable computer to power off. In some
circumstances, the device powers off automatically. You can then reboot the device.
Devices
®
Do not remove the battery until the LED indicator is off. If you remove the battery when the device
is on or sleeping, any data collected could be lost.
You should not turn off the device if the LED indicator is blinking red (A500, T5-series and T2-series),
unless it has been blinking red for several minutes. If a wearable computer is turned off when its
LED indicator is blinking red, it may not be ready to use when it is turned back on.