Table of Contents
Advertisement
Receiver Front
1.
Power/Link Indicator Light
• Blinking indicator light - Establishing link between the
Transmitter and the Receiver.
• Solid indicator light - Link between the Transmitter
and Receiver has been established and is ready for
signal transmission.
2.
HDMI
• The HDMI indicator light will be illuminated when the
HDMI port is selected for video output.
• If there is no signal, and/or the cable is not
connected, the indicator light will blink.
3.
COMPO
• The COMPO (component) indicator light will be
illuminated when component output is selected for
video output.
• If there is no signal, and/or the cable is not
connected, the indicator light will blink.
4.
AV
• The AV indicator light will be illuminated when the AV
port (composite) is selected for the video output.
• If there is no signal, and/or the cable is not
connected, the indicator light will blink.
5.
IR Window
• IR receiving window enables remote control of the
transmitter and/or source components.
6.
Link/Output Selection Button
• When powered on: Press for 1 second to select the
video output source. Each press of the button
will cycle through the available video outputs
"HDMI→ COMPO→ AV →HDMI" in sequence.
• Press and hold for 8 seconds until all indicator lights
blink synchronously, you are now in Scan/Pairing
Mode.
8
1
2
3
4
5
6
Advertisement
Table of Contents
