Table of Contents
Advertisement
Tips
If the Transmitter and Receiver are not establishing a connection:
1.
It is recommended to unplug the power to both units for 30 seconds and then plug them back in.
2.
If the above tip does not assist, please reference the Factory Reset section of this manual.
If the connection has been established and the HD FLOW3 logo can be seen on the display device, but content is not playing
when initiated:
1.
Ensure that source cables are properly connected.
2.
Ensure the Transmitter is set to the proper input port and that the Receiver is set to the proper output port.
3.
Ensure the source is operating.
4.
The display device needs to be able to support the resolution of the media source that is being streamed. Utilizing the INFO
button, while connected via HDMI, will allow you to see the EDID resolution data that the display device accepts.
(Example - If the display device supports the highest resolution of 720p but the source device is outputting 1080p content,
the content needs to be downscaled to the maximum resolution of the display device, in this case 720p).
If the HD FLOW3 logo nor the video content are being displayed, verify that the output selection on the Receiver and input
selection of the display are correct. Also, make sure cables are completely pressed into place and secure, and that the selected
source content is playing.
Indicator Lights Decoded
1.
Transmitter/Receiver
• Power/Link Indicator Light:
Flashing - Units are booting and establishing a secure connection for AV transfer.
Solid - Link between the Transmitter and Receiver(s) has been established and is ready for signal transmission.
• All Indicator Lights:
Lights blinking sequentially from top to bottom - Unit is in Scan Pairing Mode searching for other HD FLOW3
devices.
2.
Transmitter:
• HDMI1, HDMI2, HDMI3, PC, AV - The indicator light will be lit to indicate the input that is currently selected. If the
selected input does not have a connection or the signal from the media source is not present, the selected input
indicator light will be flashing.
3.
Receiver:
• HDMI, COMPO, AV - The indicator light will be lit to indicate the output that is currently selected. If no output device
is connected to the selected output port the indicator light will be flashing.
Factory Reset
CAUTION:
Factory reset will revert all settings to factory defaults. It is not recommended to perform a factory reset on multicast
systems (systems with two or more receivers) as the pairing will be forgot. One will have to re-pair the additional
receivers if a factory reset is completed.
To complete a factory reset, complete each of the steps below for both the transmitter and receiver. These do not need to be
done at the same time.
1. Unplug the device from its power source.
2. Press and hold the Link/Source (Tx) or Link/Output (Rx) Selection button on the front panel.
Plug the DC power back into the unit being reset.
3. Continue holding the Link/Source (Tx) or Link/Output (Rx) Select button for about 6 seconds until all lights blink at the same
time then release.
4. Allow the system to re-start and show content.
How To Check Firmware Version
1. Make sure the HD FLOW3 System is up and running.
2. Using the HD FLOW3 remote supplied, point it at the Receiver IR window. Press the Info/OK button. In the list of
information there will be stated "Firmware Version:"
15
Advertisement
Table of Contents
