Table of Contents
Advertisement
D) Connecting The Receiver To The Display Device
Note: Connect the Receiver to the display device using
the port with the highest capable resolution; HDMI port
is preferred. The HD FLOW3 is a video switch, and as
such will upconvert all inputs with resolutions of 480p,
720p, and 1080i/p through the HDMI Output.
A. HDMI Output to Display
• Connect the HDMI cable from the Receiver's
HDMI output to the display device's HDMI input.
B. Composite Output to Display
• Connect the composite RCA cable from
the Receiver's AV output to the display device's
composite input.
C. Component Output to Display
• Video - Connect the component video (YPbPr)
cable from the Receiver's COMPONENT-OUT to
the display device's component input.
• Audio - A 3.5mm-to-RCA stereo audio cable
is required (not included) to transmit audio when using this input. Connect the 3.5mm end of the cable to the Receiver's
AUDIO-OUT port, then connect the RCA side of the cable to the RCA ports on the display device.
E) Powering-up HD FLOW3 Wireless AV Multi Display System
1.
Plug in the power adaptors for the Transmitter and the Receiver to available power outlets.
2.
Plug in the other end of the power cables to the Transmitter and then to the Receiver. The
units will automatically turn on.
3.
Turn on your display device (TV, monitor, projector, etc.).
4.
While turning on the display device, the HD FLOW3 System will be going through the
start up process. The process takes approximately 45 seconds to complete. The
Power/Link Indicator Light on the Transmitter and Receiver should be flashing at first.
Flashing indicates that the units are establishing a secure connection. Wait until the
connection is successfully established, indicated by a solid Power/Link light on the
Receiver.
F) Input And Output Selection
1.
Select the output used to connect the Receiver to the display. There are two ways to choose output sources on the
HD FLOW3 Receiver:
a. Using the provided remote - Press the desired output while pointing the remote at the Receiver.
b. Using the Link/Output Selection Button on the Receiver - To toggle between outputs press the Link/Output Selection
Button for one second on the unit and release.
At this time the output Indicator Light will become solid and the HD FLOW3 logo will appear on the display device if there
is no source providing content. The HD FLOW3 logo is only displayed when the receiver is working with the display, but no
content is coming from the transmitter.
2.
Turn on the desired media source device that is connected to the Transmitter.
3.
Select the desired media source input on the Transmitter. There are two ways to select the source input on the HD FLOW3
Transmitter:
a. Using the provided remote - Press the desired input while pointing the remote at the Transmitter.
b. Using the Link/Source Selection Button on the Transmitter - To toggle between Inputs press the Link/Source
Selection Button for one second on the unit and release.
4.
Play the source device media content and enjoy up to a Full HD 1080p wireless entertainment experience.
Notes:
1. Audio and video sources will switch simultaneously whether using the remote or Selection Buttons.
2. Inputs on the Transmitter and Receiver can be switched by pointing the remote at the Transmitter or Receiver ONLY if
the connection between Transmitter and Receiver has been established, indicated by a solid link light. If the connection
between Transmitter and Receiver has not been established, the inputs need to be selected at the location of each unit
using either of the above input and output selection methods.
13
Advertisement
Table of Contents
