Table of Contents
Advertisement
Multicast Mode - Pairing Additional Receiver(s) With The Transmitter (Optional)
Multicast Wireless Mode enables the Transmitter to stream AV media from one Transmitter to up to six Receivers.
Note: Your HD FLOW3 Wireless AV Multi-Display System comes pre paired. This section is only needed if you have
separately purchased additional Receiver(s).
If you have purchased additional Receiver(s) use the following instructions to add the Receiver(s) to the current system,
or follow the steps in the HD FLOW3 Receiver manual. The system can have receivers added at any time.
Each receiver will have to be paired with the transmitter one at a time. Do not begin pairing another receiver until the previous
receiver has rebooted after pairing as described in the steps below. A maximum of 6 receivers may be paired to one transmitter.
1.
Press and hold the "Link/Source" button on the transmitter for 8 seconds. The lights will blink sequentially from top to
bottom. The transmitter will remain in pairing mode for 2 minutes or until it senses a receiver trying to link.
2.
Press and hold the "Link/Output" button on the desired receiver for 8 seconds. The lights will first blink sequentially from top
to bottom; then in various patterns. After about 30 seconds the receiver will successfully link with the transmitter and then
shut off and reboot itself. The entire process will take under 1 ½ minutes and video will not appear on the display until the
process is complete. Video on the additional paired receivers will be lost during this process.
3.
Repeat steps 1 and 2 for each additional receiver, if any.
Peer-To-Peer LAN (Wired) Mode Installation
1.
Connect the LAN cable between the LAN ports on the
Transmitter and Receiver.
2.
Plug both the Transmitter and Receiver into power.
3.
When the HD FLOW3 system powers up it will detect
the wired connection upon power up and not enter
wireless mode. The boot process should be complete in
about 45 seconds. . The WiFi indicator lights on the front
of both the Transmitter and the Receiver will be solid.
Note:
To return the units back to WiFi mode, unplug power on both Transmitter and Receiver, then unplug the LAN cable, and repower
the Transmitter and Receiver. The video and audio will be lost during this process.
14
Advertisement
Table of Contents
