Arcam Solo movie 2.1 Handbook page 24

Note that you need to change the system Controlling the volume of
code on the product you wish to control,
other devices
as well as the remote.
By default, the volume keys and mute key
1. The device keys that may be Locked or
control the amplifier volume.
Unlocked.
You can configure these buttons so they
2. Lock and Unlock are toggles (they
send volume commands to another
change from Lock to Unlock to Lock,
device. In the following example, the
etc.).
volume commands are sent to a linked AV
3. Press and hold the Device and 6 keys
device (your television, for instance):
together for three seconds.
4. The power LED stays lit, showing that
it is in Lock/Unlock setup mode.
5. If there is no further key input for 30
seconds, the LED goes off and the
remote leaves Lock/Unlock setup
The volume and mute keys will now send
mode.
the volume commands to the TV.
6. To verify the status of a device, press
To set the volume buttons to control the
the 3 6 9 keys in sequence:
amplifier once more, repeat the above
7. f Lock is set, the LED blinks three
steps, except press AMP in step 3.
times: *** .
8. If Unlock is set, the LED blinks five
times: ***** .
9. If you press a valid Device key within
30 seconds, the LED blinks three
times: *** and the remote leaves
Lock/Unlock setup mode.
Hidden commands
Command
AMP+ '
AMP+ ,
Factory default reset
1. Press AV+5 for three seconds, until the
You can reset your remote to the original
LED lights and stays on.
factory default settings.
2. Press VOL UP.
Press and hold both the
3. Press AV again. The LED blinks three
and MENU keys for about five seconds
times *** .
until the power LED blinks five times
***** .
All programming and setup codes that
you have entered into the remote are
erased and the remote returns to the
original factory default settings.
Device codes
The tables that begin on "device code
Effect tables" on page DC-1 (at the end of
this user manual) list 3-figure codes for
Sends a Power On
different manufacturers' devices.
command
Use these when setting your remote up
Sends a Power Off
to control your devices, as described in
command
"Direct code setup (Method 1)" on page
E-22.
If more than one code number is listed,
try the first number. If the results are
unsatisfactory, continue trying the
numbers for that manufacturer to get the
(HOME)
best 'fit' with the functionality required.
If the manufacturer of your equipment is
not listed, you can try "Library search setup
(Method 2)" on page E-22. This method
allows you to scan through every code
contained in the remote's memory.
E-24