Page 1
Custom Installation Notes: Serial programming interface and IR remote commands for Arcam Solo Movie 2.1 and 5.1 ����������� ��� MENU SOURCE INFO VOLUME ���� POWER TAPE ����������� ��� MENU SOURCE INFO VOLUME ���� POWER TAPE Models covered: Solo Movie 2.1...
Solo Movie 2.1 2.7 onwards Solo Movie 5.1 2.7 onwards The latest version of this document is available on the Arcam Dealer extranet accessed via www.arcam.co.uk/extranet If you cannot yet access the Dealer extranet, please apply by email to nadinec@arcam.co.uk RS232 Arcam (A&R Cambridge Ltd), Pembroke Avenue, Waterbeach, CAMBRIDGE, CB25 9QR, England...
Introduction Solo Movie is fitted with an RS232 serial connector that allows remote control from a PC, or similar device. This section of the document describes the protocol for controlling Solo Movie 2.1 or 5.1 via the RS232 interface. Conventions <...
Zone Data 0x21 0x01 0x0A 0x02 0x01 0x04 0x0D Note: RS232 control is disabled if the iPod option is enabled. RS232 Arcam (A&R Cambridge Ltd), Pembroke Avenue, Waterbeach, CAMBRIDGE, CB25 9QR, England (solo movie) +44 (0)1223 203200 www.arcam.co.uk/extranet...
Response to the DAB MPEG mode request: 0x00 Response to the DAB data rate request: 0x00 Response to the signal strength request: 0x00 RS232 Arcam (A&R Cambridge Ltd), Pembroke Avenue, Waterbeach, CAMBRIDGE, CB25 9QR, England (solo movie) +44 (0)1223 203200 www.arcam.co.uk/extranet...
IR remote commands The following tables give the IR (infrared) remote commands accepted by the Arcam Solo Movie. AMP commands TUN commands System code 16 System code 17 Decimal Code Command Decimal Code Command 16-0 Source SAT 17-0 Tuner Number 0...
Standby On 25-30 DVD Slow Play Forward 25-31 DVD Slow Play Back 25-32 DVD Track Forward 25-33 DVD Track Back 25-37 Trims RS232 Arcam (A&R Cambridge Ltd), Pembroke Avenue, Waterbeach, CAMBRIDGE, CB25 9QR, England (solo movie) +44 (0)1223 203200 www.arcam.co.uk/extranet...