Arcam Solo movie 2.1 Handbook page 23

Deleting the learned data
To delete all the learned data for a
To delete the learned data for a key for
device:
a device:
1. Press the Device key for the product
1. Press the Device key for the product
you want to set up, together with the
3 key. Hold down both buttons for
three seconds until the LED stays lit.
2. Press and hold down the Device key
2. Press and hold down the key on which
for the product that you want to erase,
together with the 4 key for three
seconds until the LED blinks twice
** .
3. If any further key press is not made for
30 seconds after the LED blinks twice
3. If any further key press is not made
** , the remote leaves erase mode
without deleting the learned data.
4. If you press the Device key one more
time within 30 seconds after LED
blinks twice ** , you can finish
4. If you press the Device key together
the erase mode deleting all the data
learned on the Device. The LED blinks
three times *** to confirm.
Reading stored code
numbers
1. Press the Device key for the product
that you want to set up together with
the 4 key. Hold down both keys for
three seconds until the LED blinks.
2. Press the INFO key and count the
you want to set up, together with the
number of blinks ( * =1, ** =2,
3 key. Hold down both buttons for
*** =3, etc.). There is a time
three seconds until the LED stays lit.
gap between digits. (Note that
'0' is represented by ten blinks:
you want to delete the data for three
********** .)
seconds. The LED blinks twice ** .
If any further key press is made, the
remote escapes from erase mode
without deleting the learned data.
for 30 seconds, the LED blinks twice
** , the remote get out of the erase
mode automatically without deleting
the learned data.
with the 3 key again within 30
seconds after the LED blinks twice,
all the data learned for that Device is
deleted and you leave erase mode.
The LED blinks three times ***
in confirmation.
Locking/Unlocking a
specific device mode
When you first unpack your remote and
insert the batteries, it is able to control
certain Arcam components automatically
(e.g. Amplifiers, Tuners and Disc Players).
We achieve this by programming specific
Arcam device codes onto the relevant
device mode keys, then locking the device
modes so you don't reprogram them
inadvertently.
If you want to override these locked
default settings – to control a third-party
amplifier, for example – you will first need
to unlock AMP mode before setting up the
remote using one of the learning methods
described on the previous page.
E-23
The factory default settings are:
Device Default Default
mode status codes
001 (Arcam
AMP Locked
code 16)
Code
AV Unlocked
learning only
SAT Unlocked 128 (Sky+)
018 (Humax
PVR Unlocked
9300)
Code
GAME
Unlocked
learning only
Code
LINE Unlocked
learning only
Code
AUX Unlocked
learning only
030 (Bush,
STB Unlocked Goodmans,
Grunding)
108 (Philips
TV Unlocked
TV)