Change An 802.1Q-Based Vlan - NETGEAR GS908E User Manual

8-Port Gigabit Ethernet Smart Managed Plus Switch Model GS908E
7. Specify the settings for the new VLAN:
• VLAN Name. Enter a name from 1 to 20 characters.
• VLAN ID. Enter a number from 1 to 4094.
• Ports. Select the ports that you want to include in the VLAN through a combination of the following
actions:
- Click the TAG ALL button to add all ports as tagged ports to the VLAN.
- Click the UNTAG ALL button to add all ports as untagged ports to the VLAN.
- Click the EXCLUDE ALL button to exclude (remove) all ports from the VLAN.
- Click the T button for a port to add the port as a tagged port to the VLAN.
- Click the U button for a port to add the port as an untagged to port the VLAN.
- Click the E button port to exclude (remove) the port from the VLAN.
For a selected port, the T button (for a tagged port) or U button (for an untagged port) displays blue.
For an unselected port, the E button (for an excluded port) displays blue.
Note If ports are members of the same LAG, you must assign them to the same VLAN.
For information about setting the new VLAN as the voice VLAN, see
VLAN as the Voice VLAN and Adjust the CoS Value
8. Click the APPLY button.
Your settings are saved. The new VLAN shows in the 802.1Q-based VLAN section.

Change an 802.1Q-Based VLAN

You can change the settings for an existing 802.1Q-based VLAN.
To change an 802.1Q-based VLAN:
1. Open a web browser from a computer that is connected to the same network as the switch or to the
switch directly through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
The login page displays.
3. Enter the switch password.
The default password is password. The password is case-sensitive.
The HOME page displays.
4. From the menu at the top of the page, select SWITCHING.
The Quality of Service (QoS) page displays.
5. From the menu on the left, select VLAN.
The VLAN page displays.
Use VLANS for Traffic Segmentation
42
Set an Existing 802.1Q-Based
on page 45.