Configuring Group Policy - Epson FX-890IIN Network Manual

FX-890IIN/FX-2190IIN/FX-2175IIN Network Guide
Items
IPsec/IP Filtering
Access Control
Authentication Method
Pre-Shared Key
Confirm Pre-Shared Key
Encapsulation
Remote Gateway(Tunnel Mode)
Security Protocol
Related Information
"Configuring Default Policy" on page 40
&

Configuring Group Policy

A
Access the printer's Web Config and select Network Security Settings > IPsec/IP Filtering > Basic.
B
Click a numbered tab you want to configure.
C
Enter a value for each item.
Security Settings
Settings and Explanation
You can enable or disable an IPsec/IP Filtering feature.
Configure a control method for traffic of IP packets.
Permit Access Select this to permit configured IP packets to pass
through.
Refuse Access Select this to refuse configured IP packets to pass
through.
IPsec Select this to permit configured IPsec packets to pass
through.
Displays compatible authentication methods.
Enter a pre-shared key between 1 and 127 characters.
Enter the key you configured for confirmation.
If you select IPsec for Access Control, you need to configure an encapsulation
mode.
Transport Mode If you only use the printer on the same LAN, select this.
IP packets of layer 4 or later are encrypted.
Tunnel Mode If you use the printer on the Internet-capable network
such as IPsec-VPN, select this option. The header and
data of the IP packets are encrypted.
If you select Tunnel Mode for Encapsulation, enter a gateway address between 1
and 39 characters.
If you select IPsec for Access Control, select an option.
ESP Select this to ensure the integrity of an authentication
and data, and encrypt data.
AH Select this to ensure the integrity of an authentication
and data. Even if encrypting data is prohibited, you can
use IPsec.
41