Epson FX-890IIN Network Manual page 43

FX-890IIN/FX-2190IIN/FX-2175IIN Network Guide
Items
Access Control
Local Address(Printer)
Remote Address(Host)
Method of Choosing Port
Service Name
Transport Protocol
Local Port
Remote Port
Authentication Method
Pre-Shared Key
Confirm Pre-Shared Key
Security Settings
Settings and Explanation
Configure a control method for traffic of IP packets.
Permit Access Select this to permit configured IP packets to pass
through.
Refuse Access Select this to refuse configured IP packets to pass
through.
IPsec Select this to permit configured IPsec packets to pass
through.
Select an IPv4 address or IPv6 address that matches your network environment. If an
IP address is assigned automatically, you can select Use auto-obtained IPv4 ad-
dress.
Enter a device's IP address to control access. The IP address must be between 0 and
43 characters. If you do not enter an IP address, all addresses are controlled.
Note:
If an IP address is assigned automatically (e.g. assigned by DHCP), the connection
may be unavailable. Configure a static IP address.
Select a method to specify ports.
If you select Service Name for Method of Choosing Port, select an option.
If you select Port Number for Method of Choosing Port, you need to configure an
encapsulation mode.
Any Protocol Select this to control all protocol types.
TCP Select this to control data for unicast.
UDP Select this to control data for broadcast and multicast.
ICMPv4 Select this to control ping command.
If you select Port Number for Method of Choosing Port and if you select TCP or
UDP for Transport Protocol, enter port numbers to control receiving packets,
separating them with commas. You can enter 10 port numbers at the maximum.
Example: 20,80,119,5220
If you do not enter a port number, all ports are controlled.
If you select Port Number for Method of Choosing Port and if you select TCP or
UDP for Transport Protocol, enter port numbers to control sending packets, sep-
arating them with commas. You can enter 10 port numbers at the maximum.
Example: 25,80,143,5220
If you do not enter a port number, all ports are controlled.
If you select IPsec for Access Control, select an option.
Enter a pre-shared key between 1 and 127 characters.
Enter the key you configured for confirmation.
43