Epson FX-890IIN Network Manual page 33

FX-890IIN/FX-2190IIN/FX-2175IIN Network Guide
Items
Enable LLMNR
LPR Settings
Allow LPR Port Printing
Printing Timeout (sec)
RAW(Port9100) Settings
Allow RAW(Port9100) Printing
Printing Timeout (sec)
RAW(Custom Port) Settings
Allow RAW(Custom Port) Printing
Port Number
Printing Timeout (sec)
IPP Settings
Enable IPP
Allow Non-secure Communication
Communication Timeout (sec)
URL(Network)
Printer Name
Location
FTP Settings
Enable FTP Server
Communication Timeout (sec)
SNMPv1/v2c Settings
Enable SNMPv1/v2c
Access Authority
Community Name (Read Only)
Community Name (Read/Write)
Security Settings
Setting value and Description
Select this to enable LLMNR. You can use name resolution without NetBIOS even if
you cannot use DNS.
Select to allow printing from the LPR port.
Enter the timeout value for LPR printing between 0 to 3,600 seconds. If you do not
want to timeout, enter 0.
Select to allow printing from the RAW port (Port 9100).
Enter the timeout value for RAW (Port 9100) printing between 0 to 3,600 seconds. If
you do not want to timeout, enter 0.
Select to allow printing from the RAW port (Custom Port).
Enter the port number for RAW (Custom Port) printing between 1024 to 65535
except 9100, 1865, and 2968.
Enter the timeout value for RAW (Custom Port) printing between 0 to 3,600 seconds.
If you do not want to timeout, enter 0.
Select to enable IPP communication. Only printers that support IPP are displayed.
You cannot use AirPrint if this is disabled.
Select to allow the printer to communicate without any security measures (IPP).
Enter the timeout value for IPP printing between 0 to 3,600 seconds.
Displays IPP URLs (http and https) when the printer is connected by wired LAN. The
URL is a combined value of the printer's IP address, Port number, and IPP printer
name.
Displays the IPP printer name.
Displays the IPP location.
Select to enable FTP printing. Only printers that support FTP printing are displayed.
Enter the timeout value for FTP communication between 0 to 3,600 seconds. If you
do not want to timeout, enter 0.
Select to enable SNMPv1/v2c. Only printers that support SNMPv3 are displayed.
Set the access authority when SNMPv1/v2c is enabled. Select Read Only or Read/
Write.
Enter 0 to 32 ASCII (0x20 to 0x7E) characters.
Enter 0 to 32 ASCII (0x20 to 0x7E) characters.
33