HPE FlexNetwork 10500 series Configuration Manual page 55
Network management and monitoring
Hide thumbs
Also See for FlexNetwork 10500 series:
- Security command reference (881 pages) ,
- Security configuration manual (702 pages) ,
- Network management and monitoring command reference (423 pages)
Table of Contents
Advertisement
Figure 7 Network diagram
NQA client
10.1.1.1/24
10.3.1.1/24
Device A
Configuration procedure
# Assign IP addresses to interfaces, as shown in
# Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
# Create an ICMP echo operation.
<DeviceA> system-view
[DeviceA] nqa entry admin test1
[DeviceA-nqa-admin-test1] type icmp-echo
# Specify 10.2.2.2 as the destination IP address of ICMP echo requests.
[DeviceA-nqa-admin-test1-icmp-echo] destination ip 10.2.2.2
# Specify 10.1.1.2 as the next hop. The ICMP echo requests are sent through Device C to Device B.
[DeviceA-nqa-admin-test1-icmp-echo] next-hop ip 10.1.1.2
# Configure the ICMP echo operation to perform 10 probes.
[DeviceA-nqa-admin-test1-icmp-echo] probe count 10
# Set the probe timeout time to 500 milliseconds for the ICMP echo operation.
[DeviceA-nqa-admin-test1-icmp-echo] probe timeout 500
# Configure the ICMP echo operation to repeat every 5000 milliseconds.
[DeviceA-nqa-admin-test1-icmp-echo] frequency 5000
# Enable saving history records.
[DeviceA-nqa-admin-test1-icmp-echo] history-record enable
# Set the maximum number of history records to 10.
[DeviceA-nqa-admin-test1-icmp-echo] history-record number 10
[DeviceA-nqa-admin-test1-icmp-echo] quit
# Start the ICMP echo operation.
[DeviceA] nqa schedule admin test1 start-time now lifetime forever
# After the ICMP echo operation runs for a period of time, stop the operation.
Device C
10.1.1.2/24
10.2.2.1/24
10.3.1.2/24
10.4.1.1/24
Device D
10.2.2.2/24
10.4.1.2/24
Device B
Figure
7. (Details not shown.)
44
Advertisement
Table of Contents
