Table of Contents
Advertisement
2.4 Configuration through TELNET command
1. Make sure that you have a TCP/IP network already installed.
2. Run command shell (i.e. Windows MS-DOS prompt).
3. inSentry will initially try to acquire an IP address from the DHCP network
service, if exist, on the network.
4. Type "Telnet <IP address obtained from DHCP>" and press enter. Proceed
to Step 7.
5. If there is no DHCP network service on the network, contact your network
administrator to get an IP address for you workstation that has the same
network's address as the inSentry's default IP address.
address of inSentry is 172.17.XXX.ZZZ where XXX and ZZZ is the last two pairs of
the MAC address of inSentry in decimal.
6. Type "Telnet 172.17.XXX.ZZZ" command and press enter.
7. From this point, the configuration procedures are the same as the
configuration via RS-232.
18
The default IP
Advertisement
Table of Contents
