Table of Contents
Advertisement
Figure 2-5 Select Direct to COM Port Connection
4. Setup the COM port parameters - 9600 bps, 8 data bits, no parity, 1 stop
bit and no flow control (see Figure 2-6).
Figure 2-6 Setup of the COM Port Parameters
5. Press the reset button at the back of the unit. Wait for inSentry to boot up.
Messages will then are displayed on the screen (see Figure 2-7);
afterwards, key in the password (default password is admin). The inSentry
configuration utility main menu will be displayed on the screen.
Figure 2-7 inSentry Configuration Menu
11
Advertisement
Table of Contents
