Table of Contents
Advertisement
4. Level
Use this control to adjust the level of the
currently edited delay line (or the
"source" if its 'EDIT' button is enabled).
5. Position
Fine Tuning
Should you need more precision, please use
these controls which work as classic knobs.
Shift + Mouse: Fine tune
PC
MAC
Ctrl
Command
+ Left Click : Center
Horizontal axis
The position of the white spot on this axis can be used to adjust stereo panning.
This parameter affects both "Main" and "Aux" outputs in
User manual
Use this control to adjust the amount of
signal to be re-injected into the delay
line.
This parameter is not available for the
"source", of course!
Note: You can get an infinite loop by
setting 'feedback' to 0dB.
Vertical axis
The position of the white spot on this axis
defines the proportion of signal sent to
"Main" and "Aux" outputs.
In
mode, this parameter is just
ignored.
The
mode must be selected to
activate this feature.
If needed (and available in your DAW), you
should find more information about how to
make use of extra outputs of a plug-in in
the manual of your DAW.
mode.
21
Advertisement
Table of Contents
