Table of Contents
Advertisement
PRELIMINARY
At this time you can also change other settings. Refer to
Appendix A, AP Web Server for more information about each
configuration option.
26. You must reboot the AP to enable any configuration change. To reboot the AP, click on
the REBOOT AP button that appears.
Command-Line Interface
The following procedures show the steps required to configure the AP SSID and
channel frequency using the command-line (CLI) interface and HyperTerminal.
3. After the AP boots and the operating system software loads, press Enter
to invoke the AP login: prompt. When prompted, enter the following
information to log in:
27. Press Enter to complete the login process. The Actiontec Access Point Software revision
prompt will appear.
Actiontec Electronics, Inc.
Username: Admin (case sensitive)
Password: ***
Chapter
COMPANY CONFIDENTIAL
2
Advertisement
Table of Contents
