Huawei AR1200 Series Configuration Manual page 176

Huawei AR1200 Series Enterprise Routers
Configuration Guide - MPLS
[P1] interface gigabitethernet 1/0/0
[P1-GigabitEthernet1/0/0] ospf ldp-sync
[P1-GigabitEthernet1/0/0] quit
# Configure P2.
<P2> system-view
[P2] interface gigabitethernet 1/0/0
[P2-GigabitEthernet1/0/0] ospf ldp-sync
[P2-GigabitEthernet1/0/0] quit
Step 4 Set a value for the hold-down timer on the P1 and P2 interfaces.
# Configure P1.
<P1> system-view
[P1] interface gigabitethernet 1/0/0
[P1-GigabitEthernet1/0/0] ospf timer ldp-sync hold-down 8
[P1-GigabitEthernet1/0/0] quit
# Configure P2.
<P2> system-view
[P2] interface gigabitethernet 1/0/0
[P2-GigabitEthernet1/0/0] ospf timer ldp-sync hold-down 8
[P2-GigabitEthernet1/0/0] quit
Step 5 Set a value for the hold-max-cost timer on the P1 and P2 interfaces.
# Configure P1.
<P1> system-view
[P1] interface gigabitethernet 1/0/0
[P1-GigabitEthernet1/0/0] ospf timer ldp-sync hold-max-cost 9
[P1-GigabitEthernet1/0/0] quit
# Configure P2.
<P2> system-view
[P2] interface gigabitethernet 1/0/0
[P2-GigabitEthernet1/0/0] ospf timer ldp-sync hold-max-cost 9
[P2-GigabitEthernet1/0/0] quit
Step 6 Set a value for the delay timer on the P1 and P2 interfaces.
# Configure P1.
<P1> system-view
[P1] interface gigabitethernet 1/0/0
[P1-GigabitEthernet1/0/0] mpls ldp timer igp-sync-delay 6
[P1-GigabitEthernet1/0/0] quit
# Configure P2.
<P2> system-view
[P2] interface gigabitethernet 1/0/0
[P2-GigabitEthernet1/0/0] mpls ldp timer igp-sync-delay 6
[P2-GigabitEthernet1/0/0] quit
Step 7 Verify the configuration.
After completing the preceding configuration, run the display ospf ldp-sync interface command
on P1. The interface status is Sync-Achieved.
<P1> display ospf ldp-sync interface gigabitethernet 1/0/0
Interface GigabitEthernet1/0/0
HoldDown Timer: 8
LDP State: Up
----End
Issue 01 (2012-04-20)
HoldMaxCost Timer: 9
OSPF Sync State: Sync-Achieved
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 MPLS LDP Configuration
165