Configuring The Ingress Of The Static Cr-Lsp - Huawei AR1200 Series Configuration Manual

Huawei AR1200 Series Enterprise Routers
Configuration Guide - MPLS
Step 5 Run:
destination ip-address
The destination address of the tunnel is configured, which is usually the LSR ID of the egress
node.
Different types of tunnels need different destination addresses. When the tunnel protocol is
changed to MPLS TE from other different protocols, the configured destination is deleted
automatically and needs to be reconfigured.
Step 6 Run:
mpls te tunnel-id tunnel-id
The tunnel ID is configured.
Step 7 Run:
mpls te signal-protocol cr-static
The signal protocol of the tunnel is configured to be static CR-LSP.
Step 8 Run:
mpls te commit
The current tunnel configuration is committed.
----End

3.2.5 Configuring the Ingress of the Static CR-LSP

To set up a static CR-LSP, specify the ingress node of the CR-LSP.
Context
Perform the following steps on the ingress of a static CR-LSP:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
static-cr-lsp ingress { tunnel-interface tunnel interface-number | tunnel-name }
destination destination-address { nexthop next-hop-address | outgoing-interface
interface-type interface-number }
bandwidth ]
The LSR is set as the ingress of the specified static CR-LSP.
To modify the destination destination-address, nexthop next-hop-address, outgoing-
interface interface-type interface-number, or out-label out-label, run the static-cr-lsp
ingress command to set a new value. There is no need to run the undo static-cr-lsp ingress
command before changing a configured value.
Issue 01 (2012-04-20)
NOTE
If MPLS TE parameters on a tunnel interface are modified, run the mpls te commit command to activate
them.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
*
out-label out-label [ bandwidth [ ct0 | ct1 ]
3 MPLS TE Configuration
186