Installing The Cut-Sheet Feeder - Epson FX-890II User Manual

High-capacity cut-sheet feeder:
You can use either one of these separately, or you can use both feeders together as a double-bin
cut-sheet feeder to automatically load two different types of single-sheet paper.
The single-bin cut-sheet feeder holds up to 50 single sheets. The high-capacity cut-sheet feeder holds
up to 150 single sheets or up to 25 envelopes.
Caution:
!
Do not load multipart forms, carbon paper, or labels in the cut-sheet feeder.
To install the single-bin, high-capacity, or double-bin cut-sheet feeder, see "Installing the cut-sheet
feeder" on page 124. However, you must assemble the double-bin cut-sheet feeder before installing it.
To load paper in a bin, see "Loading paper in the single-bin cut-sheet feeder" on page 126, or "Loading
paper in the high-capacity cut-sheet feeder" on page 129.
Note:
You cannot install and use the optional cut-sheet feeders when the tractor unit is installed in the pull
position. See "Removing the tractor from the pull position" on page 38 for instructions on removing the
tractor from the pull position.

Installing the cut-sheet feeder

The installation procedure is the same for the single-bin, high-capacity, and double-bin cut-sheet
feeders.
Follow these steps to install the cut-sheet feeder:
Note:
Before you install the double-bin cut-sheet feeder, you need to assemble it. See "Assembling the double-
bin cut-sheet feeder" on page 132 for instructions.
1. Make sure the printer is turned off. Then open the paper guide cover by pulling its back edge
toward.
FX-890II/FX-890IIN/FX-2190II/FX-2190IIN
FX-890II/FX-890IIN
FX-2190II/FX-2190IIN
Options and Consumables
User's Guide
C80638*
C80640*
124