Caution:
c
Do not load multipart forms, carbon paper, or labels in the
cut-sheet feeder.
To install the single-bin, high-capacity, or double-bin cut-sheet
feeder, see "Installing the cut-sheet feeder" on page 172.
However, you must assemble the double-bin cut-sheet feeder
before installing it. To load paper in a bin, see "Loading paper in
the single-bin cut-sheet feeder" on page 175, or "Loading paper
in the high-capacity cut-sheet feeder" on page 180.
Note:
You cannot install and use the optional cut-sheet feeders when the tractor
unit is installed in the pull position. See "Removing the tractor from the
pull position" on page 42 for instructions on removing the tractor from
the pull position.
Installing the cut-sheet feeder
The installation procedure is the same for the single-bin,
high-capacity, and double-bin cut-sheet feeders.
Follow these steps to install the cut-sheet feeder:
Note:
Before you install the double-bin cut-sheet feeder, you need to assemble
it. See "Assembling the double-bin cut-sheet feeder" on page 185 for
instructions.
1. Make sure the printer is turned off. Then open the paper guide
cover by pulling its back edge toward.
172
Options and Consumables