Epson FX-890II User Manual page 57

Caution:
!
Never use the knob to adjust the top-of-form position; this may damage the printer or cause it to
lose the top-of-form position.
Note:
❏ This mode can be used even when the printer cover is opened.
❏ The top-of-form position setting remains in effect until you change it, even if you turn off the printer.
❏ The top margin setting made in some application software overrides the top-of-form position setting
you make with the Micro Adjust function. If necessary, adjust the top-of-form position in your
software.
Follow these steps to adjust the top-of-form position:
1. Make sure the printer is turned on.
2. Load paper then lift up the printer cover.
Note:
If the tractor is in a push position, press the Load/Eject button to advance continuous paper to the
current top-of-form position.
3. Hold down the Pause button for about three seconds. The Pause light starts flashing and the
printer enters the Micro Adjust mode.
4. Press the LF/FF button to move the top-of-form position down on the page, or press the Load/
Eject button to move the top-of-form position up on the page.
Note:
❏ The printer has a minimum and a maximum top-of-form position. If you try to adjust it beyond
these limits, the printer beeps and stops moving the paper.
FX-890II/FX-890IIN/FX-2190II/FX-2190IIN User's Guide
Paper Handling 57