Cancelling Printing - Epson FX-890II User Manual

Note:
❏ To print the instruction sheet and alignment patterns, you need four single sheets or four pages of
continuous paper of at least the following sizes:
Paper type
Continuous paper
Single sheet
❏ If you use single sheets, you need to load a new sheet of paper each time the printer ejects a printed
sheet from the sheet guide.
❏ The setting instructions are printed in the language that you set in the default-setting mode. If you
want to change the language of the setting instructions, change the language setting by changing the
default setting. See "Changing default settings" on page 97 for instructions on changing the default
setting.
Follow the steps below to perform bidirectional adjustment.
1. Make sure paper is loaded and the printer is turned off.
Caution:
!
Whenever you turn off the printer, wait at least five seconds before turning it back on;
otherwise you may damage the printer.
2. While holding down the Pause button, turn on the printer. The printer enters the bidirectional
adjustment mode and then prints instructions and the first set of alignment patterns.
3. As described in the instructions, compare the alignment patterns and select the pattern with the
best alignment. Then select the pattern with the best alignment for each of the remaining sets of
alignment patterns.
4. After you select the best pattern in the final set of alignment patterns and save your selection by
pressing the Tear Off/Bin button, turn off the printer and exit the bidirectional adjustment mode.

Cancelling Printing

If you encounter problems while printing, you may need to cancel printing.
FX-890II/FX-890IIN/FX-2190II/FX-2190IIN
FX-890II/FX-890IIN
241 × 279 mm
(9.5 × 11 inches)
A4 or letter size
User's Guide
FX-2190II/FX-2190IIN
376 × 279 mm
(14.8 × 11 inches)
A3 landscape
Troubleshooting 112