Drain Water Hose - Dometic NDE1402 Installation And Operating Instructions Manual

Step 2: Two screws installed in the top frame.
Open the doors and fasten the refrigerator with two
screws through the holes underneath the top decoration
panel. See FIG. 7.
FIG. 7
STEP 3: Two screws installed in the rear base.
See FIG. 8.
FIG. 8
6
Failure to follow the sequence in securing refrigerator in
enclosure can cause leakage between the frame and
cabinet.
Any space between the counter, storage area or ceiling
and top of the refrigerator greater den 1-1/2 inches should
be blocked. The heat produced at the rear of the refrig-
erator will become trapped in this space, making the top
of the refrigerator hot and reduce the efficiency of the
refrigerator.

Drain water hose

A hole must be drilled through flooring see FIG. 8.
The hole must be drilled in the cut out opening of the
base plate at the rear of the refrigerator. The installer
MUST make sure that the hose does not kink when run
through the floor. Seal around the hose that goes through
the drilled hole. If a longer hose than supplied is required
to get the water to drain outside of the vehicle, the in-
staller will have to supply the extra length of hose.
Hole for drain
water hose