Dometic NDR 1062 Installation And Operating Instructions Manual
Refrigerator for lp-gas and electric operation
Hide thumbs
Also See for NDR 1062:
- Installation and operating instructions manual (21 pages) ,
- Diagnostic service manual (34 pages) ,
- User manual (24 pages)
Advertisement
Quick Links
NDR1062 installation and operating Instructions 822706504 French 3307778.005
REFRIGERATOR FOR LP-GAS AND ELECTRIC OPERATION.
NDR 1062
Automatic-Manual Energy Selector
FOR YOUR SAFETY
If you smell gas:
1. Open windows.
2. Don't touch electrical switches.
3. Extinguish any open flame.
4. Immediately call your gas supplier.
FOR YOUR SAFETY
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
WARNING: Improper installation,
adjustment, alteration,service or
maintenance can cause injury or
property damage. Refer to this
manual. For assistance or additional
information consult a qualified
installer, service agency or the gas
supplier.
USA
Service Office
The Dometic Corporation
509 South Poplar Street
LaGrange, IN 46761
Phone: 219-463-4858
822 70 65-04
INSTALLATION AND
OPERATING INSTRUCTIONS
Corporate Office
2320 Industrial Parkway Elkhart, IN 46515
For Service Center Assistance
Call: 800-544-4881
Contents:
Installation
Operating Instructions
Maintenance & Service
AVIS
Cet appareil doit être réparé
seulement par un réparateur
autorisé. Modification de
l'appareil pourrait être
extrèmement dangeruse, et
pourrait causer mal ou mort.
CANADA
Dometic Distribution Inc.
866 Langs Drive
Cambridge,Ontario
N3H 2N7 Canada
Phone: 519-653-4390
Page
4
8
12
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Dometic NDR 1062
Summary of Contents for Dometic NDR 1062
- Page 1 NDR1062 installation and operating Instructions 822706504 French 3307778.005 INSTALLATION AND OPERATING INSTRUCTIONS REFRIGERATOR FOR LP-GAS AND ELECTRIC OPERATION. NDR 1062 Automatic-Manual Energy Selector Contents: FOR YOUR SAFETY Page If you smell gas: Installation Operating Instructions 1. Open windows. Maintenance & Service 2.
- Page 3 Heater Cover, Reigniter Flue baffle Power module cover Protection cover Screw for protection cover Burner jet 12 Volt Manual gas Terminal block shutoff valve Drain water hose Inlet fitting FIG. 1 Flexible cord 2 - WAY display panel. FIG. 2 LEGEND 2-WAY AMES Model 1.
- Page 4 GAS CONNECTION INSTALLATION Hook-up to the gas supply line is accomplished at the GENERAL INSTRUCTION manual gas valve, which is furnished with a 3/8" SAE This appliance is designed for storage of foods (UNF 5/8" -18) male flare connection. All completed and storage of frozen foods and making ice.
- Page 5 AWG wire size to be used. Should the wire be too small for the distance, a voltage drop will result. Recommended wire sizes are shown below. Maximum total conductor wire length in feet and meters. NDR 1062 2-way FIG. 4 min. wire size 17 ft.
- Page 6 Hole for drain water hose FIG. 8 FIG. 6 Any space between the counter, storage area or ceiling and top of the refrigerator greater than 1-1/2 inches should be blocked. The heat produced at the rear of the Once the lower front strip is slipped under the hinge, refrigerator will become trapped in this space, making the part is possible to swing into place as shown in the top of the refrigerator hot and reduce the efficiency...
- Page 7 For ventilation VENTILATION HEIGHTS height, see table VENTILATION HEIGHTS See Figures 9, and 10. Installation with roof Minimum ventilation vent and lower side vent heights in Refrigerator Inches NDR 1062 63 3/4 1620...
- Page 8 Depth inch 60-51/64 24-7/8 26-5/8 59-15/16 23-11/16 NDR 1062 1544 1522 This method of installation and these clearances will give you adequate space for service and proper installation. OPERATING OPERATION INSTRUCTIONS Before starting the refrigerator, check that all the manual gas valves are in the ON position.
- Page 9 2 - WAY display panel. THERMOSTAT START UP INSTRUCTIONS The thermostat on the refrigerator controls both the gas A. A continuous 12 volt DC supply must be available for and electric operation, thereby eliminating the necessity the electronic control to function. of resetting each time a different energy source is em- B.
- Page 10 2 - WAY display panel. DESCRIPTION OF OPERATING LIMP MODE OF OPERATION This control system contains a feature where it will MODES continue to operate the cooling system in the event of a failure of a major operating component. Two different modes of operation can occur in this category.
- Page 11 LOW AMBIENT SWITCH water and placing them in the freezer compartment. All RV absorption refrigerators, while similar, operate a little differently than your home refrigerator. Dometic designers and engineers have equipped your refrigera- tor with an exclusive feature that allows for trouble-free ! CAUTION operation in low ambient temperature (like below 50°F)
- Page 12 Refer to section INSTALLATION, page 4 to 8. PERIODIC MAINTENANCE FUSES To keep your Dometic refrigerator operating efficient- The 2-way AMES models are equipped with 2 fuses, one ly and safely, periodic inspection and cleaning of for the refrigerator control system and one for the AC several components once or twice a year is recom- cartridge heater.
- Page 13 B. Check all connections in the LP gas system (at the ! WARNING back of the refrigerator) for gas leaks. The LP gas DO NOT use a wire or pin when cleaning the burner supply must be turned on. Apply a non-corrosive jet as damage can occur to the precision opening.
- Page 14 Conversion Kit Number. For further information, please 293 27 50-08/2 Door reversing kit, right-left contact the Dometic Corporation listed on the front page. (light brown) 293 27 50-09/0 Door reversing kit, left-right...
- Page 15 CERTIFIED VENT SYSTEM KITS Refr. Model Components Drawing NDR 1062 Roof Vent 3103633 Base 3103634 Cap (Both Required) Lower Side Vent 3102364 3102277 3102970 3102972 3101534 3101782 3101337 For further information, contact your dealer or distributor.
- Page 16 Positioning of shelves Put a screwdriver into the slot of the shelf lock. Insert the ends of the wire shelf on the left-hand side at the desired position. Turn the screwdriver counterclockwise. Remove the shelf locks from the wire shelf. Slide the wire shelf to the left.
- Page 20 MO-FO 0111...
Need help?
Do you have a question about the NDR 1062 and is the answer not in the manual?
Questions and answers