Triumph T595 Daytona Owner's Handbook Manual page 46

1. Expansion Tank
2. Tank Cap
3. 'MAX' Mark
4. 'MN' Mark
Coolant Level
Inspection
A
WARNING: Do not remove
the radiator cap when the
engine is hot. When the engine is hot,
the coolant inside the radiator is hot
and also under pressure. Contact
with this hot, pressurised coolant will
cause scalds and skin damage.
Position the motorcycle on level
l
ground and in an upright position.
Remove the seat.
l
Check the coolant level in the
l
expansion tank. The coolant level
must be between the 'MAX' and 'MIN'
marks.
If the level of coolant is too low,
l
remove the cap from the expansion
tank, and add coolant mixture
through the filler opening to the 'MAX'
mark. Refit the cap.
Maintenance and Adjustment
Page 45
NOTE
If the coolant level is being
l
checked because the coolant has
overheated, also check the level in
t h e r a d i a t o r a n d t o p - u p i f
necessary.
In an emergency, water alone can
l
be added to the cooling system.
However, the coolant must be
returned to the correct mixture
ratio as soon as possible.
CAUTION:
m u s t b e u s e d w i t h t h e
antifreeze (see specification for
antifreeze) in the cooling system.
If hard water is used in the system, it
causes scale accumulation in the
water passages, and considerably
reduces the efficiency of the cooling
system.
If coolant must be added often, or the
expansion tank runs dry, there is
probably a leak in the system. Have
the cooling system inspected by your
authorised Triumph dealer.
Distilled water