Safety Information: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Page 3
Positioning This heater is water resistant to IP24. It can therefore be used in bathrooms or other areas subject to humidity, The heater must be installed so that switches and other controls cannot be touched by a person in the bath or shower. The heater must be mounted on the wall, with a minimum height of 300mm above the floor or any other objects heated below it, and a minimum distance of 400mm below the ceiling and from adjacent walls.
Page 4
Thermostat The heat output is regulated by a built-in thermostat. The thermostat maintains the required ambient temperature by automatically turning the heater on and off. Starting from the ‘Freeze Guard’ position, turn the thermostat knob clockwise until you hear a ‘click’. The heater will then start heating and the LED indicator will light up.
Filter This heater is fitted with an air filter to Air Filter protect the heating elements from dust and dirt. The filter is removable and can be fitted from either the left or right hand side of the heater. To keep the heater operating efficiently, remove and clean the filter once every six months.
Need help?
Do you have a question about the S2044 and is the answer not in the manual?
Questions and answers