Table of Contents
Advertisement
Second wash cycle
Open the control panel.
1.
Remove the water tank, rinse thoroughly, fill with
2.
water and reinsert.
Close the control panel.
3.
Touch the
#
touch button.
4.
The appliance is rinsed. As soon as the wash cycle
has finished, an audible signal sounds.
Final cleaning
Open the control panel.
1.
Empty and dry the water tank.
2.
Switch off the appliance.
3.
Descaling is complete and the appliance is ready for
use again.
pRails
With good care and cleaning, your appliance will retain
R a i l s
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
shelves and clean them.
Detaching and refitting the rails
:
Warning – Risk of burns!
The rails become very hot. Never touch the hot rails.
Always allow the appliance to cool down. Keep children
away from the appliance.
Detaching the rails
Pull out the pull-out forwards.
1.
Push the front rail forwards and up (fig.
2.
detach it (fig.
).
"
Then swing the entire rail outwards
3.
at the rear
(fig.
).
ƒ
#
) and
!
and detach it
‚
Clean the rails with cleaning agent and a sponge. For
stubborn deposits of dirt, use a brush.
Inserting the holders
If the holders fall out when you remove the rails, these
must be re-inserted.
The holders at the front differ from those at the rear
1.
(fig.
).
!
Use the hook to mount the front holder at the top
2.
into the round hole
‚
it at the bottom, and straighten it
Use the hook to attach the rear holder into the upper
3.
hole
and push it into the lower hole
‚
Attaching the rails
When hanging the rails, ensure that the pull-out is at the
bottom.
The rails only fit on the right or the left side. The pull-out
rails must pull out forwards.
Rails
, set it at a slight incline, attach
(fig.
).
ƒ
"
(fig.
ƒ
en
).
#
29
Advertisement
Table of Contents
