Adjusting Filtration - Master Spas MP Force Owner's Manual

Spa Controls

adjusting filtration

MAIN FILTRATION
Using the same navigation and adjustment as Setting the Time, Filter Cycles are set using a start
time and a duration. Each setting can be adjusted in 15-minute increments. The panel calculates
the end time and displays it automatically.
Filter Cycles
Filter Cycle 1
Starts at 12:00 AM
Back
Runs 0 HR 0 Min
Ends at 12:00 AM
Filter Cycle 2 NO
Starts at 12:00 AM
Runs 0 HR 0 Min
Ends at 12:00 AM
FILTER CYCLE 2 - OPTIONAL FILTRATION
Filter Cycle 2 is OFF by default.
Simply touch the Filter Cycle 2 line in the highlighted area, and when "NO" is highlighted, press
Up or Down to toggle Filter Cycle 2 on and off. When Filter Cycle 2 is ON, it can be adjusted in the
same manner as Filter Cycle 1.
It is possible to overlap Filter Cycle 1 and Filter Cycle 2, which will shorten overall filtration by the
overlap amount.
PURGE CYCLES
In order to maintain sanitary conditions, as well as protect against freezing, the system will purge
water from the respective plumbing by running briefly at the beginning of each filter cycle.
If the Filter Cycle 1 duration is set for 24 hours, enabling Filter Cycle 2 will initiate a purge when
Filter Cycle 2 is programmed to begin.
DO NOT DIVE.
Filter Cycles
Filter Cycle 1
Starts at
Back
Runs
Ends at 9:15 AM
Filter Cycle 2 NO
Starts at 12:00 AM
Runs 0 HR 0 Min
Ends at 12:00 AM
50
6:15 AM
3 HR 0 Min
MasterSpaParts.com