Table of Contents
Advertisement
7.
RIDE model ice machine start up procedure
The start-up procedure below is intended to ensure that ice machine is operating properly after installation has
been made. Check each item listed and call factory immediately for assistance if you experience problems with
unit.
§ Ice machine MUST be sanitized prior to operation!
§ Consult Operation and Service Manual provided with ice machine for sanitizing instructions.
7.1
Before turning on power
1. Turn on water to ice machine.
2. Check that hose clamp securely holds ice transport tube on nozzle.
7.2
After turning on power
1. Turn on power to ice machine and confirm that gearmotor, fan motor and compressor start immediately.
2. Check that ice begins to enter bin area within approximately 10 minutes.
3. Put ice against bin level thermostat in dispenser bin and check that compressor and gear motor shut
down immediately after thermostat opens. Fan will continue to run for an additional 10 minutes.
4. Check that ice machine comes back on in approximately 20 minutes (bin signal must be present).
10
NOTICE!
Maestro Plus
Bin • RIDE Technology
Advertisement
Table of Contents
