Programmed Playback; Tape Playback - THOMSON RK200CD Operating Instructions Manual

REPEAT , REPEAT ALL AND MIX PLAYBACK
Press PLAY MODE button during stop mode. CD plays with a single track repeat,
all tracks repeat or randomly.
FOR NORMAL COMPACT DISC PLAYBACK
Mode sequence REPEAT >> REPEAT ALL >> MIX >> CLEAR.
During Repeat 1 mode, display shows
During Repeat 2 mode, display shows

PROGRAMMED PLAYBACK

PROGRAMMED PLAYBACK
Programmed playback enables tracks on a disc to be played
in the desired order. Up to 20 tracks can be programmed.
1. Press the " PROGRAM " button.
2. Press the " NEXT " and " BACK " buttons to select the
desired track number.
3. Press the " PROGRAM " button again to memorize
the track.
4. Repeat steps 2 and 3 until all desired tracks are
programmed.
5. Press the " PLAY/PAUSE " button to start.
" " , " PROG " & track number are shown on
the CD display.
6. Press the " STOP " button once to stop programmed
playback.
Note on CD-R/RW discs
- Because of non-standardized format definition/ production of CD-R/RW, playback quality and performance are not
guaranteed.
- Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions, such as PC performance,
writing software, media ability, etc.
- Do not attach a seal or label to either side of the CD-R/RW disc. It may cause a malfunction.
- It is recommended to record only audio files on CD-R/RW discs for easy reading.

TAPE PLAYBACK

1 . Turn on the unit by
pressing the POWER button.
2 . Press the FUNCTION button to
select TAPE.
LCD display
LCD display
POWER
FUNCTION
GB 5
During Mix mode, display shows
7. Press the " PLAY/PAUSE " button to resume
programmed playback.
8. Open the CD door, turn off the CD player or press the
" STOP " button twice to clear the programmed
memory.
Note : Programming can only be made when the player
is in stop mode.
PROGRAM
3 . Insert the cassette.
4 . Press the PLAY button.
PLAY MODE
LCD display
" PROGRAM "
LCD display
PLAY