Malaguti PHANTOM F 12 MAX 125 Workshop Manual page 64

A
- CHASSIS
A
CHAPTER
REMOVING THE REAR CALIPERS
200 cc VERSION
(Remove muffler)
•
Undo the screws (V2 - F.113).
Loosen the hydraulic transmission screw (V - F.113)
and detach the pipe from the calipers.
Caution!!! When refitting, replace the
gasket of the hydraulic screw.
CHECKING THE REAR BRAKE PADS FOR
WEAR
• Check the discs for wear. If they are worn or
scratched, have them ground.
If they are particularly damaged or are thinner
than 2 mm, replace them.
Caution!!! Minimum thickness of the
pads is 2 mm (F. 114).
REPLACING THE REAR CALIPERS
Empty the hydraulic circuit and drain fluid into a
special container so that it may be disposed of in
accordance to the laws in force concerning waste
disposal.
Caution!!! When removing the calipers,
pay special attention to prevent dam-
age to the oil duct, disc and brake pads.
After working on the braking system, make sure
that the brake fluid pipe is not twisted, that the
discs and pads are not soiled with oil or grease
and that all screws and fittings are firmly wrenched
in place.
64
PAGE
CHASSIS
DISASSEMBLY
200 cc
V
SECTION 3
V
2
F.113
2 mm
F.114
09.03
ISSUE