Restoring Factory Default Settings - Measurement Computing WebDAQ 504 User Manual

WebDAQ 504 User's Guide
To change the security level or password, open the web interface and go to the Device window, Security tab.
Use the device Reset button to restore security settings to factory default values.

Restoring factory default settings

To restore network configuration and security settings to the factory default values, use a paper clip to press the
button. When pressed, the default network and security settings are written to the device and
CONFIG RESET
the WebDAQ is rebooted.
You can change the network settings, security level, and password with the web interface. The user name
"admin" cannot be changed.
Factory default
Parameter Specification
IP address 192.168.0.101
subnet mask 255.255.255.0
Gateway 192.168.0.1
DHCP setting DHCP + link-local enabled
Security level Off
User name admin (case-sensitive)
Password admin (case-sensitive; editable)
11
Setting up the WebDAQ 504