Subscribe to Our Youtube Channel
Related Manuals for Bras QUARK 1
Summary of Contents for Bras QUARK 1
- Page 1 QUARK MANUALE D’ISTRUZIONI OPERATOR’S MANUAL CARNET D’INSTRUCTIONS GEBRAUCHSANWEISUNG MANUAL DE INSTRUCCIONES...
-
Page 2: Electrical Safety Instructions
1 ELECTRICAL SAFETY INSTRUCTIONS 3 TECHNICAL CHARACTERISTICS Before connecting the dispenser to the mains, check that the voltage shown on the rating plate matches your electricity Transparent removable bowls supply. Connect the dispenser to a single-phase supply Capacity of each bowl, approx. through an earthed socket as required by current regulations. -
Page 3: Description Of Controls
EN GLIS H Q U A R K this manual. See chapter 5.3 CLEANING AND SANITIZING Inspect the uncrated unit for any possible damage. If PROCEDURES. damage is found, call the delivering carrier immediately to file a claim. Fill the bowls with product to the maximum level mark. Do Install the unit on a counter top that will support the not overfill. -
Page 4: Operation Helpful Hints
follows: Switch D if pressed it activates the function 'SLUSH'. In this case the (F) led lights up. In machines with several tanks, pressing the key relating to the activated operating mode will then make it possible to switch off both mixing and freezing of the corresponding tank. -
Page 5: Cleaning And Sanitizing Procedures
EN GLIS H Q U A R K 7. 3 CLEANING AND SANITIZING factory preset. To change the viscosity, if needed, use a standard screwdriver to turn the adjustment screw located in PROCEDURES the rear wall of each container as follows (see figure 5): - towards right (clockwise) to obtain a thicker product (the indi- cator F will go down in opening G). - Page 6 warm (45-60 °C 120-140 °F) potable water and dishwashing detergent. Do not use abrasive detergent. Important: if present, follow label directions, as too strong a solution can cause parts damage, while too mild a solution will not provide adequate cleaning. IMPORTANT In order to prevent any damages to the dispenser use only a detergent suitable with plastics parts.
-
Page 7: Routine Maintenance
EN GLIS H Q U A R K (see figure 13). Install the top cover(s) and operate the unit. Allow the solution to agitate for about two minutes. Drain the solution out of the bowl(s). Use fresh product to chase any remaining sanitizer from the bottom of the bowl(s).
Need help?
Do you have a question about the QUARK 1 and is the answer not in the manual?
Questions and answers