Table of Contents
Advertisement
Installation Guide
Operating Instructions
General Settings:
Beep
Clock Settings
Date Format
Stamp
Language
Flicker
LCD Rotate
LCD Power Save
Protect Level
Motion Detection
Reset Setup
FW Version
Pressing the mode button while in the DVR screen will switch between the Recording,
Photo and Playback modes. Pressing the right-hand arrow button while recording will
mute the built-in microphone. Pressing the menu button while recording will lock the
current file to prevent overwriting.
Wiring Diagram
6
email - support@aampglobal.com (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - technical.eu@aampglobal.com (Europe)
4.3" Factory Mount Mirror Monitor
(continued)
Turns the button press beep on or off.
Allows you to set the current date and time.
Change the displayed format of the date.
You can set whether the date and time are permanently
embedded into the recordings.
Choose the language of the menu structure.
You can change the flicker rate between 50 and 60 Hz to
improve playback on different devices.
This allows you to invert the recording on a vertical plane.
This allows you to set the automatic turn-off of the display.
This will allow you to adjust the built in G
sensor settings (lower is less sensitive).
This will set the camera's sensitivity to movement when
using the automatic motion detect feature.
This will reset all settings to the default values.
Display the current firmware version on the unit.
Main Harness
MM-4320-DVR
with Built-In DVR
+12V Ignition
(Red)
GND
(Black)
Video Input
V1
Reverse Camera Input
V 2
Advertisement
Table of Contents
