Table of Contents
Advertisement
MM-4320-DVR
4.3" Factory Mount Mirror Monitor
with Built-In DVR
Fitting Instructions
The MM-4320-DVR will replace your factory fitted rearview mirror.
Remove the original mirror from the vehicle and replace with the
MM-4320-DVR. If your factory mounting bracket differs from the
MM-4320-DVR, there is a supplied metal button that can be bonded
to the windshield to allow the new mirror to fit.
Once the unit is in place, run the connections cable across the headliner of
the vehicle and down the A pillar.
Please ensure that you do not impede the operation of any airbags that may
be located in the A pillar of the vehicle. Any cable passing these airbags
should be run behind the airbag and not in front of it.
Once the cable has been routed down to the dashboard, connect the camera
inputs and power connections as shown in the wiring diagram section of this
manual.
Operating Instructions
Upon powering up the screen, the DVR screen will be displayed and
recording will start automatically, as long as an SD card is inserted.
The SD card slot is located on the right-hand side of the unit. Please take
care when inserting the card as improper insertion can damage the card and
the mechanism.
To switch to V1 video input, press and hold the REC button for 2 seconds.
To revert back to the DVR display, press the REC button again briefly.
The screen will automatically switch to V2 when it detects a video signal on
that input.
Installation Guide
email - support@aampglobal.com (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - technical.eu@aampglobal.com (Europe)
3
Advertisement
Table of Contents
