Earlens Photon Instructions Manual page 26

Processor Serial Number
Should troubleshooting be necessary, Earlens may require the Processor serial number. The
number is located on the inner curve/belly of the Processor.
9.7. Earlens Charger
The Earlens Charger is designed to charge the Processors.
•
The AC wall adapter (included) is used to plug the Charger into the wall outlet. Do not plug the
Charger into an outlet that is difficult to access.
•
The Charger can house and charge two Processors at the same time when connected to the
wall power adapter.
•
Do not use any other Charger or AC wall adapter with the Earlens Hearing Aid, or use the
Earlens Charger to charge any other devices. Using the incorrect Charger or AC wall adapter
can damage the devices.
•
The LED lights on the front of the Charger indicate the charge status for each Processor. When
the Processor is first placed in the Charger a single light will blink for 3 seconds while the
Processor and Charger are communicating. Table 2 details what each indicator light means.
Table 2: Charger indicator status
9.8. Care & Maintenance
Storage
•
Store the Earlens Hearing Aid in a clean, dry location out of direct sunlight. Avoid exposure to
excessively high or low temperatures.
•
Store the Processor and Light Tip in the Earlens Charger. The Earlens Charger is designed to
protect the Light Tip and charge the device.
Processor Battery Maintenance
•
The Processors should be docked in the Charger when not in use or stored in a clean, dry place.
•
It is recommended that Processors be charged overnight.
Cleaning
•
The Processors and Charger can be cleaned with a soft cloth to remove debris or accumulated
ear wax.
•
The Light Tips may collect wax on the end where the light is emitted. Although light can travel
through a thin layer of wax, large pieces should be removed to ensure proper functioning of the
devices. Use a soft cloth, a baby wipe or Isopropyl Alcohol (IPA) based wipes to remove wax.
•
If wax accumulates in the Light Tip vent, use a standard hearing aid cleaning tool to gently
remove it. Do not use an abrasive tool.
IFU00022vJ
26