Earlens Photon Instructions Manual page 24

•
Restore Defaults: Resets all features to recommended defaults. This feature can be located in the
Fitting screen under the Features tab. Selecting "Restore Defaults"
will not impact the fitting response of the Processors.
9.3. Removal and Replacement of the Light Tip from the
Processor
To remove the Light Tip from the Processor:
a. Hold the Processor in one hand and with the other hand
place your pointer finger under the Light Cable where it
connects to the Processor and place your thumb on top of the
Light Cable (Figure 34).
b. Gently pull the Light Cable straight out of the Processor.
To replace the Light Tip in the Processor:
a. Gently insert the Light Tip connector straight into the
Processor.
9.4. Removal and Replacement of Processor Case Cover
The Processor cover needs to be removed for programming
and for the purposes of replacement.
a. Gently pinch the top and bottom of the Processor.
This will create a small gap between the cover and
Processor near the user controls (Figure 35a).
b. Using your fingernail or flat tweezers, unsnap the cover
on each side of the user controls. The location of the snaps
is marked "X" in Figure 35b.
c. Gently lift the cover straight back.
To replace the cover (Figure 36):
a. Beginning at the bottom of the Processor, insert the case
cover tab into the opening.
b. Working along the side seams, snap each side in place
between the two user controls buttons.
c. Latch the top of the case cover into place on the Processor
housing.
Figure 34 Light Tip Removal
Figure 35 a & b: Processor case cover
removal
Figure 36: Processor case cover replacement
IFU00022vJ
24