Daikin FXAQ15AUV1B Installation Manual page 10

(4) Making sure not to catch the horizontal flaps, remove the front grille by pulling in the direction of the arrow.
CAUTION
• Remove the cardboard which is placed between filter and heat exchanger. Refer to figure below.
(3)
(2)
Fig. 7
• Remove the drain plug, the insulation tubing, and the drain hose from the drain pan and replace.
(Refer to Fig. 8)
• Connect the local refrigerant piping ahead of time, matching it to the liquid pipe and gas pipe marks
engraved on the installation plate (1).
< Replacing the drain hose and drain plug >
(1) Remove the drain plug and insulation tubing.
(2) Remove the drain hose and replace onto the left side.
(3) Replace the drain plug and the insulation tubing onto the right side.
Insulating tube
Make sure
there are
no gaps.
Fig. 8
(6) Hook the indoor unit onto the installation plate. (Refer to Fig. 9)
8
Tab position
(3) (3)
Screw position
(2)
Screw position (In case of FXAQ40,50,63 type)
Drain plug
Insert using a hexagon wrench (4mm).
Tab position
Cardboard
Front grille
(2)
Do not place lubricant (refrigerant oil) when inserting.
This may cause deterioration and water leaks.
Tab
(4)
English