M O D E . S; Listen To Other Devices; Reset; Replace A Fuse - Axis AX1507BT Installation Manual

Listen to Other Devices

To connect an external audio/video device to the unit:
1. Connect the external device with the supplied AV cable.
2. Touch the upper left corner to display the main menu.
3. Touch [AV-IN 1] front input or [AV-IN 2] rear input to access
external device.

Reset

When all functions freeze, reset the unit.
Press [ RESET ] with a ball-point pen or similar object.
Note:
When the unit has been reset, all the settings will return
to factory settings.

Replace a Fuse

If there is no power, the fuse may be damaged and need to be replaced.
1. Remove the unit from the dashboard.
2. Check all electrical connections.
3. Buy a fuse that matches the amperage of the damaged fuse.
4. Replace the fuse while the unit is powered off.

Steering Wheel Control Programming

1. Touch the upper left corner to display home menu.
2. Touch [ SWC ], the SWC menu will display.
3. Adjust each key with an individual function.
4. Touch [ Pair ] to program.
5. Press each individual steering wheel control button for each
corresponding function.
6.
the functions are saved and the programming will end.
7. Touch [ Reset ] to reset the programming.
Steering Wheel Control - Notes
Key A + Key B
A and B are the SWC positive connections. Connect to the SWC positive connections on the vehicle.
If the vehicle has only one SWC positive connection, connect only one key wire and insulate the other.
Key A has a wider detectable resistance range; Key B is able to detect resistances of closer values.
Key GND
GND is the SWC negative connection. Connect to the SWC negative connection on the vehicle.
SWC System: Analogue
Key A + Key B output voltage: 5V
Note: If the voltage does not drop below 4.8 volts, the unit will not register the button.
Internal Resistance
Key A: 4.7K
Key B: 1.5K
Maximum detectable SWC resistance
Key A: 112.8K
Other Modes
trol button is programmed,
(Also see Page 25)
20.
Reset