AudioCodes Mediant 500L Connecting Manual page 24

Figure 4-6: Software Upgrade Wizard – Files Loaded
12. Click Reset
progress' message is displayed and the device 'burns' the newly loaded files to flash
memory and then resets.
Note:
• The device's reset may take a few minutes (even up to 30 minutes) depending on the
.cmp file version.
• After the reset, the device's IP address will be the 'default' IP address 192.168.0.2
(see also Section 3.1).
After the device finishes the installation process and is reset, the following Wizard
page is displayed, showing the installed software version and other files (ini file and
auxiliary files) that you may also have installed:
Figure 4-7: Software Upgrade Process Completed Successfully
13. Click End Process to close the Wizard; the Web Login dialog appears.
14. Enter your login username and password (Admin, Admin respectively), and then click
Login; a message box appears informing you of the new .cmp file version.
15. Click OK; the Web interface becomes active, reflecting the upgraded device.
AudioCodes Mediant E-SBC
to burn the files to the device's flash memory; the 'Burn and reset in
24
BroadCloud SIP Trunk
Document #: LTRT-12552