HP XP1024 Operating System Configuration Manual page 55

CSYLE18<PUB.SYS>:ioconfig
IOCONFIG A.00.00 (catalog A.00.00) (c) 1994 Hewlett-Packard Co. All Rights Reserved
ioconfig:ap path=0/6/0; id=pci_device
ioconfig:ap path=0/6/0/0; id=a6795a
td: claimed Tachyon XL2 Fibre Channel Mass Storage card at 0/6/0/0
Scanning for fibre channel devices at 0/6/0/0. This may take a while...
ioconfig: ex
keeping to group CONFIG.SYS
Purge old configuration (yes/no)?Automatic yes
** configuration files successfully saved **
CSYLE18<PUB.SYS>:
CSYLE18<PUB.SYS>:fcscan -h
FCSCAN Version 1.1
Scanning for Fibre Channel devices.
This could take upto few minutes. Please wait ...
FCSCAN has found the following Fibre Channel I/O Adapter Cards and Devices
on this system.
Booting from the array
2. Run IOCONFIG to add the new Fibre Channel HBAs to the existing
system's I/O configuration (or run SYSGEN if you prefer, but that will
require a system reboot after the configuration has been modified). You
should have recorded the I/O paths for the HBAs when the HBAs were
installed. In this example, the A6795A Fibre Channel HBA was
installed at I/O path 0/6/0/0.
3. Run the fcscan –h utility to obtain the I/O paths for the disk array
N-ports and LUNs.
SYSGEN PATH
=============
0/6/0/0
0/6/0/0.102
0/6/0/0.102.0
0/6/0/0.102.1
0/6/0/0.102.2
0/6/0/0.102.3
... ...
CSYLE18<PUB.SYS>:
4. Choose the disk array LUN that you will use as the new MPE/iX Ldev
1 and note the BOOT MENU PATH I/O path for that disk in the fcscan
output listing. That path will become the system's primary boot path.
For this example, LUN 2 on the disk array was used at BOOT MENU
PATH 0/6/0/0.8.0.102.0.0.2
DESCRIPTION
=============
Fibre Channel Adapter
Fibre Channel N-Port
HP OPEN-3 disk
HP OPEN-3 disk
HP OPEN-3 disk
HP OPEN-3 disk
BOOT MENU PATH
================
0/6/0/0.8.0.102.0.0.0
0/6/0/0.8.0.102.0.0.1
0/6/0/0.8.0.102.0.0.2
0/6/0/0.8.0.102.0.0.3
55